11/23/2023 0 Comments Turn signal switch![]() The turn signal switch, and ignition switch have slightly different color schemes, make sure you are unplugging the correct one. The harness is on the driver side of the column. Once you have the wires exposed, unplug the turn signal switch. Slide the black plastic piece down, and remove the wires from it. Once the bracket is removed you will see a flat black plastic gaurd at the bottom, the wires are inside this. This bracket needs to be removed, there are two bolts going into the column, and one holding the bracket up, per side. Now you should be able to see the column support. There are several phillips head screws along the top, and two at the bottom. Remove the main piece that covers the speedometer and tachometer, and the center piece that covers the information center. You have to drop the column to actually get the wiring free. ![]() Use the lock plate tool to compress the lock plate, then you will see a small clip in the center. This step can be a little frustrating, as the clip can be stubborn. The steering wheel lock plate is spring loaded, so it must be removed with a special tool. Time for another special tool, this one can also be rented at most auto parts store. The cover is pretty flimsy so it will come right off. Just stick a small flat head in the three slots and pry up gently. Once the steering wheel is off, pull the dust cover off. You'll need a steering wheel puller, which can be rented at most auto parts stores. You may get lucky and just be able to pull the steering wheel off, but I doubt it. Also remove the steering wheel nut in the center. Just pull it straight off.Īt this point you may want to unplug your horn for a moment, or if you have a steady hand, you can leave it plugged in. Even though they don't go bad that often, in a Jeep that is exposed to the elements, you may eventually go through one. This warranty does not cover any OTC Product that has been abused, altered, worn out, contaminated, rusted, heated, ground, damaged due to side loading, used for a purpose other than that for which it was intended, or used in a manner inconsistent with Service Solutions/OTCs instructions regarding their use.Next in my do it yourself series, replacing a turn signal switch. OTC Jacks ARE NOT to be used as Jack Stands. Misuse of OTC Jacks will void the above warranty. ![]() Automann WILL NOT cover any labor charges, or any consequential/incidental damages or expenses. Automanns liability is limited to replacement or repair of such parts that have been found defective by them. Exposure to corrosive elements, accidents, neglect, or other abnormal service conditions will void the limited warranty. This warranty does not apply to conditions and damages resulting from misuse, abnormal or nonstandard applications, negligence, alterations, accidents, improper installation, or any form of maintenance.Īutomann offers a limited warranty on all chrome and stainless-steel bumper products for a period of one year (1 yr.) against defects in materials or workmanship. The vendor warrants all new products against defective material or workmanship for (1) year OR (100,000) miles from the date of sale, whichever comes first.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |